SOLO 2 DL Lap Timer - CAN/RS232

• Graphical Display
• Automatic Lap time calculation based upon GPS technology
• Wide internal track Database with more than 3,000 tracks
• Automatic track recognition at power on
• Freely configurable display
• 10 configurable RGB LEDs
• Freely selectable race Mode: Speed races on close circuit  performance tests
• WiFi capable for configuration and data transfer to PC
• Internal 4 GB memory
• Rechargeable lithium battery

Find your track easily and quickly

Solo 2 can rely on a database of more than 3,000 tracks all over the world: as soon as it switches on, Solo 2 identifies its position, recognizes the starting line coordinates of the track and starts sampling lap times. In case the track is not in the database, no problem: Solo 2 realizes it and enters into the autolearning mode, automatically understands the characteristics of the track and gives the lap time anyway.

The predictive lap time is much more reliable, and the configurable RGB LEDs will give you a clear and fast indication of the comparison with your best lap.

Race mode selection

Solo 2 can manage different types of races: Speed races in a closed circuit, Performance tests (0-100 km/h etc.). In each of these configurations, Solo 2 gives the proper information during the test and powerful data review immediately after each session.

Data recall on screen

At the end of your test, you can quickly review all the key information on your display.

Wi-Fi communication with the PC

Wi-Fi connection: easy, fast, without connectors nor cables: the best way to configure your Solo 2, to manage the track database, to download the data to your PC.

iPhone connection*

Use your iPhone for a quick and comfortable data analysis, for managing the track database and even for an On-Line view of the most important parameters of your Engine (in case you have chosen the Solo 2 DL).

* available soon

Solo 2 DL, the Solo with ECU connection

More than 1,000 protocols for 1,000+ ECU in the database, for easily connect your Solo 2 DL to your Engine Control Unit and get a lot of information with just one cable. In case your ECU protocol is not in the database, no problem : an ECU Driver Builder is always available in the Race Studio 3 configuration software, and you will be able to create
your protocol by yourself.

Coil RPM input

Solo 2 DL now features a digital input allowing to log RPM either from square wave signals (8-50 V each signal) or pulse signals (150-450 V ignition coil trigger - primary circuit). This applies perfectly to VHC for exemple.
 

Technical Specifications